Duncan Enviro 3000e, Owner'S Manual

Page: 128 / 130

61
All motor
control modules
are offline
Harness faulty
Check continuity of yellow, green and red
cores between module connection points.
Repair or replace as necessary
System
operates while
drill is
stationary
Grass movement (or
other) in front on the
forward speed sensor
Tractor vibration
Raise the drill into the transport position or
increase the minimum forward speed
setting
Increase the minimum forward speed
setting
F TEMPORARY SOLUTIONS
The following are temporary solutions which will enable the operator to complete a job
for specific electric drive system faults or damage.
Problem Temporary Solution
Radar Access the USER OPTIONS screen, initiate the simulated speed
and change the speed to the desired setting. Seeders will
dispense product as if the drill was travelling at the specified
speed setting. Note, the seeders will only operate while the drill is
in the working position.
Area cut-out sensor Access the INSTUMENT SETUP screen and change the area cut-
out setting from ‘In Work’ to ‘Out of Work’. Seeders will dispense
seed relative to travel speed regardless of whether the drill is in
the working position or in the transport position. To stop the
seeding operation, turn the motors or the console off.
Priming switch Initiate the calibration program procedure using the console.
Shaft confirmation
sensor Access the ALARMS screen and turn the respective shaft sensor
setting to ‘Off”
Bin level sensor Access the ALARMS screen and turn the respective bin level
sensor setting to ‘Off”
Blown fuse Disconnect the fuse box, bolt the power cable ends together and
ensure exposed connection can not come into contact with tractor
parts resulting in a short circuit. The use of insulation tape is
recommended.
Motor or motor
control module (MCM)
No temporary solution is available. Replace part required.
Harness or power
cables
No temporary solution is available unless wire or connection
damage can be identified.