331 Auto Creaser 7
Chapter 4 INSTALLATION
4.1 Output tray, stops and guides
Unpack it , install the parts as per above illustration.
Note: Set guide and stops according to the paper format.
The capacity of the tray should always less than 30mm (A3 ) to keep machine
balance.
4.2 Feeding extension
We can see there are 3 screws on trail of feeding table, and there are 3 holes
on side of extension table.
Install them as per following steps:
1: Loosen 3 screw, but not remove
2: Connect extension table, with each screw head through a hole, clip the
extension table on.
3: Tighten 3 screws.
Magnetic side guide
Output tray
Side guide R/H
Back stop
Side guide L/H
Joint of tray
and machine
