179
8. Appendix
LIGHT Indicator
Indicator display
Projector status
Procedure
Off
The light module is turned
off.
–
Flashing
Red (six times
per cycle)
The light source is not
turned on.
Wait for over 1 minute and try to power ON the projector again.
If the problem still persists, contact the projector customer
support center.
Lit
Green
Light module lit
–
TEMP. Indicator
Indicator display
Projector status
Procedure
Off
No problem
Flashing
Red (cycles
of 2)
Temperature problem
The temperature protector has been activated. If the room
temperature is high, move the projector to a cool place. If the
problem still persists, contact the projector customer sup-port
center.
Lit
Orange
High surrounding tempera-
ture (Forced ECO Mode)
The surrounding temperature is high. Lower the room tempera-
ture.
If the temperature protector is activated
If the projector’s internal temperature rises abnormally, the light module turns off and the temperature indicator flashes
(repeatedly two flashes per cycle).
It may happen that the projector’s temperature protector is simultaneously activated and the projector’s power turns off.
If this happens, do the following:
-
Unplug the power cord from the power outlet.
-
If using in a place where the surrounding temperature is high, move the projector to a different, cool place.
-
If there is dust in the ventilation slits, clean. (
→
)
-
Wait as such about 1 hour for the projector’s internal temperature to lower.
