Important Information
xxii
Clearance for Installing the Projector
• When installing the projector, keep sufficient space around it, as described below. If not, the hot
exhaust emitted from the projector may be taken back in.
Also, make sure no wind from an air-conditioner hits the projector.
The projector’s heat control system may detect an abnormality (temperature error) and automati-
cally shut off the power.
Exhaust vent
Intake vent
Exhaust vent
Intake vent
Exhaust vent
Intake vent
30 cm/12" or greater
20 cm/8" or greater
20 cm/8" or greater
30 cm/12" or greater
NOTE:
• In the above figure, it is assumed that there is sufficient space above the projector.
• For the portrait projection, each required clearance between the floor and the intake or the exhaust vent is same with the
clearance on the upper illustration. See page
for an installation example on portrait projection.
• When using multiple projectors together for multi-screen projection, provide sufficient space
around the projectors for air intake and exhaust. When the intake and exhaust vents are obstructed,
the temperature inside the projector will rise and this may result in a malfunction.
Precautions for Ceiling Installation
Do not install the projector in the following places. Attached substances such as oil, chemicals and
moisture may cause deformation or cracks of the cabinet, corrosion of the metal parts, or malfunction.
• Outdoors and places with humid or dust
• Places exposed to oil smoke or steam
• Places where corrosive gases are generated
About Copyright of original projected pictures:
Please note that using this projector for the purpose of commercial gain or the attraction of public
attention in a venue such as a coffee shop or hotel and employing compression or expansion of the
screen image with the following functions may raise concern about the infringement of copyrights
which are protected by copyright law.
[ASPECT RATIO], [KEYSTONE], Magnifying feature and other similar features.
[AUTO POWER OFF] Function
The factory default setting for [AUTO POWER OFF] is 15 minutes. If no input signal is received and no
operation is performed on the projector during 15 minutes, the projector is automatically powered
off for saving the power consumption. In order to control the projector by an external device, set
the [AUTO POWER OFF] to [OFF]. Please refer page
for details.
Summary of Contents for 6710UL
Page 1: ...Projector 6710UL 6782UL User s Manual For USA ...
Page 239: ......
