5
5.
PAIR THE SIREN WITH THE CONTROL PANEL (LEARNING)
DURING THE LEARNING PROCEDURE AVOID TRANSMISSSION FROM OTHER RADIO DEVICES (EG.: DETECTORS).
ALWAYS MOUNT THE ANTENNA ON CONTROL PANEL FOR RADIO RECEIVING.
THE SIREN CAN BE LEARNED ONLY IN ONE OF THE TWO MODES (“BI-DIRECTIONAL” OR “DETECTION”)
CONTROL PANELS WITH “BI-DIRECTIONAL LEARNING” FUNCTION
VERIFY THE CONTROL PANEL HAS THE “BI-DIRECTIONAL” FUNCTION, IF NOT FOLLOW THE PROCEDURE
DESCRIBED BELOW.
1.
Control panel
: enter in Installer Menu:
Select the “TX Code” item and set a value different from “000” (zero-zero-zero)
Select the “Bi-directional learning” item, select an empty memory position (indicated with “
O
” symbol).
2.
Siren
: set
DIP1
to
ON
: the siren emits a long “beep” and lights on the lamp
3.
Control panel
: press – within 30 seconds – the button for start the procedure (“
X
” or “
”).
The control panel and the siren will learn their radio codes (this operation is automatic).
4.
If all ends correctly: the control panel displays “Learning OK”. The siren emits some “beep”, the lamp blinks some times and then
stay solid on.
5.
Siren
: set
DIP1
to
OFF
: the siren emits a “beep” and switch off the lamp. Close the cover of the siren.
6.
In case of errors, repeat the procedure.
CONTROL PANELS WITHOUT THE “BI-DIRECTIONAL LEARNING” FUNCTION
THE CONTROL PANELS “AN” VERSION MUST BE SET IN “DETECTION LEARNING” MODE.
1.
Control panel
: enter in Installer Menu
Enable the radio codes transmission on control panel
[CE100-8, CE100-3: set the “TX Code” different from “000”]
[CE60-3: set the “TX Code” different from “000” or learn an activator in memory position “Activator 01”]
Select the “Radio Zones Learning” item, select an empty memory position (indicated with “
O
” symbol).
2.
Siren
: set
DIP2
to
ON
. And press the
TAMPER switch
.
The siren transmits its TAMPER radio code for
five times
(one blink for each transmission).
If the code is learned correctly, the control panel displays a solid “
X
” symbol.
3.
After the TAMPER code transmission, the siren waits for the radio code from control panel (emits one “beep” and switch on the
lamp).
4.
Control panel
: exit from Installer Menu
The control panel sends its radio code and the siren learns it (the siren emits two “beep” and one blink).
If the siren does NOT learn the control panel radio code, the lamp lights solid on: make a disarming, the control panel transmits its
radio code and the siren learn it.
5.
Siren
: set
DIP2
to
OFF
(the siren emits three “beep”).
