10
ENGLISH
L2000651 Installation guide for DucoBox Silent (Revision N | 13.07.2020)
06.B
Installer / User mode
To add components to the network, remove or replace, the system should be put in ‘Installer mode’� The LED on each component
indicates the active mode of the component (see table in next section)�
‘Installer mode’ can be activated by pressing the DucoBox Silent ‘INST’ button (see drawing in section "04�A Connections & but-
tons" on page 8�) Once the LED on the master unit starts flashing, it means that ‘Installer mode’ is active� Press ‘INST’ again to
return to ‘User mode’ (LED fully on or off)� The system reverts automatically to ‘User mode’ after 15 minutes of inactivity�
06.C
LED indications
RED (blinking slowly)
Not in network
RED (blinking rapidly)
Logging in
GREEN (blinking slowly)
In network
GREEN (blinking rapidly)
In network, waiting for associated components
YELLOW (clignotement rapide)
Transitional phase (please wait)
YELLOW (on) Initialising (system
configuration in progress)
WHITE or OFF
Normal
BLUE
Component is displayed if changes are being put through via the master�
ORANGE
The system is not working correctly because the DucoBox has not been calibrated� Restart the
DucoBox� Follow the guidelines in ‘10 essential tips’ if the problem recurs continually�
06.D
Setting type of home
Setting the type of home and number of occupants correctly will provide the ventilation system with a better basis to adjust the
mid-position� There are two types of home: low-rise (e�g� a house) and high-rise (e�g� a flat)� Configuration of this component is
obligatory in the Netherlands. The standard setting for a DucoBox is as a low-rise home for 4 (or more) occupants�
Setting type of home
1
Ensure that ‘Installer Mode’ has been activated (via the ‘INST’ button)�
2
Press ‘LOW’ for a low-rise or ‘HIGH’ for a high-rise home�
3
The yellow LED (see illustration) will flash in a pattern that indicates the
number of occupants: Once, twice (applies for 3 occupants as well) or 4
times (applies for 4 occupants or more)� Press ‘LOW’ or ‘HIGH’ respectively
again until the LED pattern matches the correct number of occupants�
4
Press the ‘INST’ button to exit ‘Installer mode’�
or
HIGH
LOW
INST
