A
B
C
D
E
F
G
H
L
M
N
P
Impianto elettrico
Electric system
sezione / section
P 7
62
749R
- M.Y. 2006 - edizione/edition 00
Funzione “TRIP”
La funzione “TRIP” visualizza la
distanza percorsa, espressa in
centinaia di metri, con un limite di
999.9 km. Durante la visualizzazione
“TRIP” si azzera il dato memorizzato
premendo il tasto SX del cruscotto
per almeno 2 secondi.
Lap time
Il cruscotto permette la
memorizzazione di 19 tempi sul giro.
Associati a ogni giro, vengono
memorizzati i dati relativi alla velocità
e ai giri motore massimi raggiunti.
Il tempo sul giro viene visualizzato
nella parte inferiore sinistra del display
LCD mentre, sulla destra, compare
il numero del giro a esso associato.
Il display visualizza la velocità
massima raggiunta, mentre il contagiri
si posiziona sul valore massimo
memorizzato. Se i giri motore
visualizzati superano il regime di
accensione delle spie di cambiata,
queste ultime vengono accese
secondo la logica di funzionamento
normale.
Lap time run
La partenza e l'arresto del cronometro
avviene tramite la pressione del
pulsante “START” se sono rispettate
le seguenti condizioni:
cruscotto in modalità “LAP”
(premendo il tasto SX);
motocicletta in movimento;
motore acceso;
pulsante “START” rilasciato.
Lo “START” e lo “STOP” del
contatore, collegato a questa
funzione, può avvenire attraverso
l'uso del pulsante “START”.
Durante il conteggio, la sigla “LAP”
lampeggia: allo “STOP” viene
visualizzato il tempo, mentre il
contatore si azzera e riprende a
contare fino al successivo “STOP”.
Il cruscotto è predisposto per la
rilevazione automatica del tempo
sul giro tramite il sistema “Magneti
Marelli MT906/C e MT907/C”.
Il sistema, per questa funzione,
utilizza due componenti: il primo è
un trasmettitore a raggi infrarossi
codificato, mentre il secondo è un
sensore la cui uscita viene collegata al
cruscotto. Quando il sensore rileva il
segnale del trasmettitore, il cruscotto
blocca in automatico il conteggio in
corso e fa ripartire il cronometro
incrementando il contatore dei giri.
TRIP counter function
The trip counter function displays the
distance ridden in hundreds of
metres, with a limit of 999.9 km.
During display of the trip counter, you
can reset the count to zero by holding
down the LH instrument panel button
for at least 2 seconds.
Lap time
The instrument panel can record up to
19 lap times. The maximum speed
and engine speed are also recorded
for each lap.
The lap time is displayed at the bottom
LH corner of the LCD, while the lap
number is displayed to its right.
The display shows the maximum
speed reached, while the rev counter
displays the maximum rpm recorded.
If the engine speed displayed exceeds
the gear change threshold, the gear
change lights will come on in
accordance with their normal
operating logic.
Lap time run
The chronometer is started and
stopped by pressing the START
button, under the following
conditions:
instrument panel in LAP mode
(press LH button);
motorcycle not stationary;
engine running;
START button not held down.
The lap time counter is started and
stopped by pressing the START
button. While the chronometer is
running, the “LAP” symbol flashes:.
When it is stopped, the lap time is
displayed; the chronometer resets
and starts a new lap count time until
the STOP button is pressed again.
The instrument panel is equipped for
automatic lap time measurement via
the Magneti Marelli MT906/C and
MT907/C system. The system uses
two components for this function:
the first is an encoded infrared
transmitter, while the second is a
sensor whose output is connected
to the instrument panel. When the
sensor reads the transmitter signal,
the instrument panel automatically
stops the current lap time count,
restarts the chronometer and
increments the lap number.
Summary of Contents for Superbike 749R 2006
