29
E
DDA data acquisition
This function activates the DDA analyzer (not fitted for this
model, but available at Ducati selling network): the DDA
must be connected to the motorcycle wiring.
To enable this function, enter the menu and set “DDA“ data
logger to “On“ by holding switch (1, fig. 8) pressed in
position B “
▼
“ for 3 seconds.
The START/STOP control for the data logger lap separator is
the high-beam flasher button FLASH ( 12, fig. 5) on the LH
switch.
If the DDA function is active and the display is suddenly
switched off (Key-Off), the function is switched off
automatically.
Note
Online assistance is available to Ducati Data Analyzer
(DDA) owners
(http://dda.prosa.com). This service will provide anything
necessary to correctly use the DDA with your PC: both for
the device and the software for analysing the recorded data.
Warning
After use, disconnect the DDA from the main wiring
harness.
fig. 22
