Ducati Monster 696 2009, Manual

Page: 662 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
P 6
72 Monster 696/696+ - M.Y. 2009 - edition 00
Electrical system
6 - Protection and safety devices
Checking protection and safety device components
Checking the key switch
Disconnect the key switch (A) from the electrical system by opening its connection (see “Routing of wiring on frame”, Sect. P 1)
and use a multimeter to check its internal connections as follows:
turn the key to
OFF and connect a multimeter to contacts (1) and (4) to check electrical continuity (Sect. P 9, Using a multimeter
to check the electrical systems concerning operation of the multimeter). The resistance reading should be near zero and,
if present, the audible continuity signal should be emitted;
turn the key to
ON and connect the multimeter to contacts (1) and (2) and then to (3) and (4) to check for electrical continuity.
The resistance reading should be near zero and, if present, the audible continuity signal should be emitted;
turn the key to
PARK and connect the multimeter to contacts (1) and (4) to check electrical continuity. The resistance
reading should be near zero and, if present, the audible continuity signal should be emitted;
turn the key to
LOCK and connect the multimeter to contacts (1) and (4) to check for electrical continuity. The resistance
reading should be near zero and, if present, the continuity sound signal should be emitted.
Notes
The same checks can also be performed using the “DDS” tester (Sect. D 5, DDS tester).
A
1 2 3 4