Ducati Monster 696 2009, Manual

Page: 485 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
N 6.2
103 Monster 696/696+ - M.Y. 2009 - edition 00
Engine
Reassembly of the clutch-side crankcase cover
Fit the plug (15) and the seal (7). Install the pressure switch (16) with its seal (14).
If the bush has been replaced, fully seat the new bush (8) in the slot in the cover using a suitable drift and a press.
If the oil seal (9) needs to be renewed, fit the new seal into the crankcase cover, positioning it so the side without a spring is
facing the circlip (11).
Before fitting, check that the edges of the circlip groove show no sign of burrs which might otherwise damage the oil seal.
Then fit the shim (10) and the circlip (11).
Important
In order for the oil seal (9) to function correctly, it must have an assembly clearance that allows the circlip (11) to rotate.
Position the sound-proofing panel (6) inside the clutch-side crankcase cover (1), aligning it with the pin (A) as shown in the figure.
Position the inner cover (17) on the panel (6), aligning it with the pin (A).
Fit the screws (20) and tighten to the specified torque (Sect. C 3, Engine torque settings).
15
7
16
14
6
17
20
11
10
8
9
A