Ducati Monster 696 2009, Manual

Page: 378 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
M 3
20 Monster 696/696+ - M.Y. 2009 - edition 00
Fuel injection-ignition system
Coil
An inductive discharge ignition system is used. Coil operation is governed by the M3C electronic control unit, which calculates
the ignition advance. The power module (integrated in the electronic control unit) also guarantees constant energy coil charge,
by adjusting the dwell time.
The horizontal cylinder coil (1) is located under the airbox; to remove it, it is first necessary to remove the LH air scoop cover
(Sect. P 3, Starter contactor).
The vertical cylinder coil (2) is located on the battery support; to remove it, it is first necessary to remove the fuel tank
(Sect. L 2, Removal of the fuel tank).
To remove the coil (1), disconnect the HT lead (3).
Unscrew the nuts (4), taking care to recover the spring washers (3).
Remove the coil (1) from the airbox.
To remove the coil (2), disconnect the HT lead (6) and remove the screws (7).
Remove the coil (2).
Refitting is the reverse of removal; tighten the nuts (4) and screws (7) to the specified torque (Sect. C 3, Frame torque settings).
Position the HT leads (3) and (6) as shown in the following photos.
Notes
To check the coils for faults, use the DDS tester and follow the instructions given in the paragraph “Guided diagnosis” (Sect. D 5).
1
3
2
6