Rear brake
Remove the rear wheel to remove the caliper plate (Sect. G 4,
Slide caliper plate out of swingarm shaft (P).
Refit the caliper mounting plate on the swingarm shaft.
Refit the rear wheel (Sect. G 4,
Refitting the rear brake system
If you have removed the speed sensor (13), position it to the caliper holder plate with the spacer (
15
) and tighten
the screw (14) to the specified torque (Sect. C 3,
). Fit the special copper gaskets (2) to the
connector when securing the brake hose (A) to the brake caliper. Fit hose connector (A) to the caliper, and position it
as shown.
Warning
Incorrectly positioned hoses can cause brake faults and interfere with moving parts.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_G_6_8_00.37.1.html (3 of 4) [10/7/2008 8:44:00 PM]