Ducati Hypermotard 950, Owner'S Manual

Page: 278 / 288

Friction material: TT 2182 FF.
Calliper cylinder diameter: 32 mm (1.26 in).
Front brake master cylinder
Front brake master cylinder: PR18/19.
Cylinder Ø: 18 mm (0.71 in).
REAR
Rear brake disc
With fixed drilled steel disc.
Disc diameter: 245 mm (9.65 in).
Disc thickness: 5 mm (0.2 in).
Maximum disc wear: 4.5 mm (0.18 in).
Rear brake control
Hydraulically operated by a pedal on RH side.
Rear brake calliper
Make: BREMBO
Calliper cylinder diameter: 34 mm (1.34 in).
Type: P34e.
Friction material: Ferit I/D 450 FF.
Rear brake master cylinder
Cylinder Ø: 11 mm (0.43 in).
Attention
The brake fluid used in the brake system is
corrosive.
In the event of accidental contact with eyes or skin,
wash the affected area with abundant running water.
Transmission
Multiplate wet clutch controlled mechanically, by the
lever on left-hand side of the handlebar. Self-servo
and slipper mechanism.
Drive is transmitted from engine to gearbox primary
shaft via spur gears.
Front chain sprocket/clutch gearwheel ratio: 33/61
6-speed gearbox with constant mesh gears, gear
change pedal on left side of motorcycle.
Gearbox output sprocket/rear chain sprocket ratio:
15/43
Total gear ratios:
1
st
gear 15/37
2
nd
gear 17/30
3
rd
gear 20/28
4
th
gear 22/26
5
th
gear 23/24
6
th
gear 24/23
Drive chain from gearbox to rear wheel.
Make: REGINA
Type: 520 ZRDK
Links: 106
277