14
Route the PCIII harness along the
right hand side frame down tube. Use
the existing wraps to hold the PCIII
harness in place (Fig. J).
15
Locate the Throttle Position Sensor
on the right hand side of the throttle
bodies.
16
Crimp the supplied wire tap to the
ORANGE wire (C position).
17
Connect the GREY wire from the
PCIII to the wire tap.
It is recommended to use dielectric
grease on these connections.
12
Repeat steps 9 &10 for the front
cylinder.
Plug the ORANGE colored wires
from the PCIII in-line of the stock
injector and GREY connector.
Plug the YELLOW colored wires
from the PCIII in-line of the stock
injector and BLACK connector
(Fig. H).
13
Remove the right hand fairing.
Fig. H
i736-411
www.powercommander.com
2008 Ducati 1098R - PCIII USB -
4
PCIII connector
Stock connector
Fig. J
18
Attach the ground wire from the PCIII
to the right hand engine cover bolt
shown in Figure K.
19
Reinstall the right hand fairing.
Ground wire
from PCIII
Fig. K
TPS
PCIII harness
Grey wire