SLICE Free Motion
Headform User’s Manual
January 2018
13
(Rev. 0)
Troubleshooting
If the LED continues to blink after 45 sec, the system did not initialize properly. To clear
the fault, reconnect the system to the power supply and PC (step 4 above), then start
SLICEWare. Manually arm and test the SLICE FMH Headform system to clear the fault.
(You must clear the fault before the system will power down.) After clearing the fault,
repeat steps 8-12 above.
Downloading Data
1.
Reconnect the system to the power supply and PC (step 4 above). Start
SLICEWare.
2.
Open the
tab. To download the total time specified by the initial test set-
up, select
. To download a region-of-interest only, enter the desired
timeframe (for example,
) and then select
.
3.
Depending on the length of the test, it may take several minutes or longer to
download the data. A download progress bar is shown in the center of the screen
alongside the corresponding DAS.
Viewing Data
1.
Open the
tab. Available data sets for viewing are shown on the left.
These data sets are stored on your PC, not the SLICE DAS.
