Qu
ick
Sta
rt |
Set-up
•
Unpack and check all parts
•
Position and fasten the ballast weights
•
Unfold and fasten the handle
•
Connect the power cable
Controls
•
Rotate the green handle to drive the
DTS220 forwards and backwards
•
Adjust the rotation of the orange handle
to control the drive speed
•
Rotate the orange handle to steer the
DTS220, rotate clockwise to turn left and
anticlockwise to turn right
•
Reset the DTS 220 and turn the stripping
mechanism on and off using the switch
1
2
Blade installation
•
Loosen the bolts
•
Lift the blade fastener
•
Insert the blade, aligning the slots
•
Fasten each bolt
•
V-blade – cuts and lifts the surface in strips,
suitable for vinyl and carpet
•
U-blade – cuts the surface into strips,
suitable for vinyl
•
Flat blade – universal blade, suitable
for all surfaces
•
Flat blade with bend – blade for tough
situations, only suitable for hard underfloor surfaces
Always remove the blade prior to transport
DT
S2
20
3
Maintenance
•
Lubricate all 3 bearings in the
stripping mechanism
•
Remove any debris from within
the stripping mechanism
•
Remove any debris from in
between the ballast weights
•
Hand clean with a damp cloth,
do not use a water hose or
steam cleaner
•
Replace the wheels as required
to ensure good traction
Safety first
•
Always wear your PPE
•
Check the area for hazards before working
•
Inspect and replace any damaged parts
•
Do not touch any moving parts
•
Remove the blade during transport
Quick tips
•
Work efficiently, create long strips
•
Reduce tyre wear by preventing wheelspin
•
Use the correct type of blade
•
Use the free wheels for quick manoeuvering
•
Regularly remove any debris from the stripping
mechanism and around the motors
•
In case of drive motor failure, remove extension
cable and use a different power source
4
Dehaco B.V. • Kruisbaak 25 • 2165 AJ Lisserbroek (NL) • T +31 (0)88 20 20 600 • [email protected] • www.dehaco.nl