I. General information
II. Receiver characteristics
III. Rival 431 receiver’s instalation
Rival 431 radio receiver is an additional device from the series of ZSP remote control system. It’s a simplified,
one-channel device devoted to gates, rollers and other devices where triggering pulse is needed. ZSP Rival 431 system
allows to broaden functioning of simple gate systems with a remote control in a cheap and easy way.
The receiver cooperates with ZSP series remotes: NEO, TIP and MAKSTER. Radio signal transmission is based on
KeeLoq® standard by Microchip® (dynamically variable code) which gives the best security. KeeLoq® system is
considered to be one of the safest coding systems.
Electric connection must be done according to
, which shows receiver with outputs description.
Connector has plugged-in wire-antenna. Also additional antenna can be used. Antenna should be switched into
connectors -( ) middle cable conductor, ( ) cable screen by concentric wire of 50
impedance.
fig.1
W
- dynamically variable code KeeLoq®,
- superheterodyne receiver, frequency 433.92 MHz,
- simple and easy, one-button interface with a built-in LED indicator,
- receiver’s memory containing 15 ZSP remote controls,
- one separated relay NO-type output with max 1A/24V AC or DC,
- operating mode: monostable, about 0.8 second,
- possibility of simple registering remotes, without the necessity of using a receiver's button,
- screw terminal block with the outside access, for connecting cables and outdoor aerial,
- supply voltage: from 12 V to 24V AC/DC,
- maximal current consumption: about 40mA (with relay on),
- tightness level: IP-53, the device devoted to surface mounting,
- working temperature: from –20°C to +55°C,
- dimensions
: in case, heigh 118, width 55, depth 27,5
[mm]
1
Fig. 1 Receiver with enclosure and connection description
programming button
LED indicator
Antenna
( )
( )
12...24V AC/DC
C1 (NO)
Legend:
1. weakening for wires in bottom part of enclosure (inside
instalation),
2. weakenings for receiver mounting,
3. clip to hold wire,
4. chamber for electric plate,
5. wire clip clousure,
6. distance sleeve for plate mounting
układu elektronicznego (screw 2,2 x 6,5),
8. case closing openings,
7. weakening for wires in top part of enclosure (surface
instalation),
3
4
5
1
2
6
7
8
39 mm
102 mm
ZSP Rival 431
A radio receiver for gate controllers
2
1
3
4
MADE IN
POLAND
