LABEL A
PPLICAT
OR
Mode Recall/
Rese
t
+
-
Mode
Recall/
Reset
+
-
Mode
Recall/
Reset
+
-
Mode
Recall/
Reset
+
-
Mode
Recall/
Reset
+
-
LABEL A
PPLICAT
OR
Mode Recall/
Rese
t
+
-
Mode
Recall/
Reset
+
-
Mode
Recall/
Reset
+
-
Mode
Recall/
Reset
+
-
LABEL A
PPLICAT
OR
Mode Recall/
Rese
t
+
-
Mode
Recall/
Reset
+
-
Mode
Recall/
Reset
+
-
Mode
Recall/
Reset
+
-
LABEL A
PPLICAT
OR
Mode Recall
/
Rese
t
+
-
LABEL A
PPLICAT
OR
Mode Recall/
Rese
t
+
-
Free Technical Support!
Contact our DTM Print support team
via email at [email protected], by
phone at +49 611 92777-0 or use the
online live chat on our webpage
dtm-print.eu. This service is free for all
our customers.
A
Unpack and Setup
1. Remove the AP550e from its
packaging.
2. Remove all items from the supply box.
3. Place the unit toward the back of a
table with a depth of 76 cm or more.
4. Connect the power and switch on the
AP550e.
Power Cord
Power Adapter
76 cm or more
Power Switch
Power Input (12v)
C
Label/Container Settings (for die-cut labels)
19. Start Labeling
15. Access Label/Container Settings
16. Sensor Calibration
17. Platform Position
18. Guide Position
Press “Mode” once.
When “F 0” is displayed hold “Mode” for
2 seconds to access Label/Container
Settings.
Press “Recall/
Reset” twice.
Push down on arm until “0.00” is
displayed.
“SC-” is displayed.
Push here
Press “Recall/
Reset” twice.
“PPo” is displayed.
Load the container.
Press and hold “+” or “-” to move
the platform to the desired label-
ing position.
Press “Recall/ Reset”
once.
“gPo” is displayed.
Container
Guide
Loosen the Thumb Screw
under the platform to adjust
the guide
side-to-side.
Thumb Screw
under platform
Press “Mode” to
store settings.
Lower the Application Arm quickly until it touches
the container.
The platform will move toward you.
Maintain downward force on the arm until the
label is completely applied.
Push here
15a
15b
16a
16b
16c
17a
17b
17c
17d
18a
18b
18c
18d
074392-190225
