Connector Configuration
13
3.4
J5 - ATX POWER SUPPLY CONNECTOR
J5 is a 2x10 pin male connector. Plug the power connector of the ATX power
supply into the connector.
Fig. 6 ATX Power Supply Connector
3.5
J6 - FLOPPY DRIVE CONTROLLER
This connector supports the floppy drive ribbon cable. After connecting the single
end to the board, connect the two plugs on the other end to the floppy drive.
3.6
J7, J8 –PRIMARY /SECONDARY IDE
CONNECTORS
These connectors support the provided IDE hard disk ribbon cable. After
connecting the single end to the board, connect the two plugs on the other end to
your hard disk or other device.
3.7
J12 – CUSTOMER IR CONNECTOR
J12 is a ten-pin connector for the IrDA/ASKIR/Customer Infrared device. The pin
definition is listed as following:
Summary of Contents for PRM-13i
