SPLINE
®
Wheels - Technical Manual
12
Con
ver
ting
t
h
e
Hub [
Ins
ert
e
d
En
d Ca
ps]
V2
01
6.
0
5
3.3
Converting the Hub [Inserted End Caps]
Removing the End Caps
Preparatory Steps
Link
Rear wheel: Remove the cassette if necessary.
see instructions of the manufacturer
Remove the brake disc.
Clean the hub.
Required Material
Specification
Amount
universal grease
as required
NOTICE
Risk of damaging the end caps!
To avoid damages, only use grind clamping jaws, aluminum clamping jaws or special tools to clamp the
end caps.
For simplification, the conversion of the hubs is only shown with a rear wheel QR hub. The following
actions are valid for all hubs with inserted end caps.
1.
Clamp the left end cap into a vise using an axle
holder.
2.
Pull the hub or the wheel upwards.
3.
Clamp the right end cap into a vise using an axle
holder.
4.
Pull the hub or the wheel upwards.
