* *
Network Public Address System
Network Display terminal
POE6401
4
DVD) to expand the program source for the
machine.
5
LED matrix screen connecting port (not
opened to the machine)
6
MIC1 pickup window
(not opened to the
machine)
The built-in microphone pickup window can
directly release audio broadcasting to the window
(not opened).
7
Microphone silent adjustment
MIC1 silent depth adjusting knob.
8
Speaker
2×10W digital power amplifier is built in the
machine
(note:
please
adopt
two-way
simultaneous output with caution due to POE
switch supply power restrictions). The output
port power is 10W. They are connected with two
constant resistance (4Ω) sound box.
9
EMC forced plug play output
The signal output from the interface is
controlled by the host machine.
10
Auxiliary output interface (AUX OUT)
It is connected with other power amplifiers,
so as to expand the terminal power.
11
MIC2 interface
Connect the microphone to realize local paging,
site talking and other functions. (Not opened to
the machine)
12
Power amplifier cooling window
13
Power (POWER)
Press "I" position to turn on the power supply and
bounce "I" position to turn off the power supply.
2.3 Instructions for remote controller structure
The structure of the remote controller is as shown in the right figure:
1. Mute key.
2. Number key:
It is used when IP address is set, and the parameter value is set.
3
.
F5:
When U disk is inserted, press F5 for play / stop.
4.
Previous track selection key:
CH+ is used to select the previous program of the current track.
5. Volume down:
V- is used to turn down the output volume of the terminal.
6. F7: play / pause key:
Press the key repeatedly for switching between play on demand and pause.
7. Enter key:
Press Enter key to adjust output at the idle state
Bass components (circulating adjustment from 0 to 15)
8.
Next track selection key:
CH- is used to select the next program of the current track.
Figure (3)
1
8
13
2
3
4
5
6
7
12
11
10
9