* *
Network Public Address System
Network Display terminal
POE6401
8
IV. Instructions for use and operation
1. Volume modification
a)
Press "VOL+" or "VOL-" key to directly adjust the play volume, press "F1" key for switching among
various volumes, switch it to the current audio source, and adjust the volume of the audio source. The
audio sources which can be switched are AUX.1, MIC.2 and MP3.3 ("AUX.1" represents the input
volume, "MIC.2" represents microphone collection volume, and "MP3.3" respects AUX OUT output
volume).
b)
It will automatically switch to the timing state after setting operation.
2
、
Modify IP address:
a)
Long press "Set" key to enter IP address to view the state.
b)
Press "VOL+" or "VOL-" key to select the parameters to be modified (the machine IP, slave machine
IP, gateway and subnet mask); after selection, it automatically switches to display the corresponding
parameter value.
c)
At the moment, press "Set" key to enter IP address modification state. When the parameter flashes,
press
key or
key to switch the parameter bit; press "VOL+" or "VOL-" key to increase /
decrease the parameter. After modification, press "play / pause" key to save the parameter. If "play /
pause" key is not pressed, the parameter modification is invalid operation.
3
、
If the nixie tube displays "IP", it represents IP address of the machine,
“
SIP.1
”
/
“
SIP.2
”
represents IP
address of the slave machine,
“
GATE
”
represents the gateway (no modification), and
“
MASK
”
represents
the subnet mask (no modification).
4
、
When the host machine is at the playing state, insert U disk, press USB to display "err" wrong indication,
which indicates that the song in U disk cannot be played. Because the priority level of the host machine is
higher than that of U disk.
Note: turn off the power supply during SD card swapping. Otherwise, it may damage SD card; when the nixie
tube displays "err", it indicates invalid operation.