* *
8 Channel Amplifier Matrix Controller
18
Explanation on priority of channels to call standby amplifier under the mode of 4 mains and multiple standbys:
each channel has no priority in the automatic call mode and follows the principle of "first call, first use". When the
four channels CH1 -- CH4 automatically call the standby power amplifier, the standby power amplifier AMP5 is
with the priority among the five standby power amplifiers (AMP5 -- AMP9). If AMP5 has been called or is in an
abnormal status, the next priority is AMP6. And so on, the final AMP9. So the priority of these 5 standby power
amplifiers is from AMP5 to AMP9.
(6)
Zone load settings
Click the "zone load setting" button on the zone setting interface as shown in Figure 3-22, and the window of
"zone load setting" as shown in Figure 3-23 will pop up. Click the icon
or
to set the alarm
threshold of zone load by 5% or 95%. When the load becomes lighter and the actual display value is less than
the set threshold, the load status bar in the main interface will display open circuit.
Figure 3-22 Zone setting interface
If one channel is not connected to zone load before starting up and is connected to the load after starting up,
the user needs to enter the zone setting interface and click the
button after “zone load initialization” to
complete the initialization setting. Click “exit and save”, the setting is successful.
