* Public Address System Intelligent Public Address System
21
4
—
9
Language selection
The device provides two languages: Chinese and English. The specific operations are as follows:
Click the ‘select language’ item under the ‘system configuration’, and a dialog box will pop up to display the
language options, then select a language (Chinese or English), click ‘OK’, and click ‘confirm’ in the confirmation
dialog box popped up, then click the ‘close system’ under the ‘system configuration’ interface to close the system
and restart it. Then, the selected language will be effective after restarting the system.
4
—
10
Paging setting
Paging is divided into normal paging and remote partition paging.
4
—
10.1
The normal paging is to page using a microphone channel of the prior input module or normal input
module.
If a prior input module is used, click the prior sound source button on the main interface, and click the
partition requiring paging (note: please close the partitions that you do not want after the prior sound
source button pops up), then you can use the emergency microphone to page (see the minimum system).
When necessary, adjust the microphone volume before pressing the prior sound source button. Please
note that, try not to use this mode to page under typical conditions, since it will hinder alarms from
breaking in.
If a normal input module is used, click the microphone sound source button on the main interface, and
click the partition requiring paging, then operate using the on-duty microphone (see the typical system).
4
—
10.2
The remote partition paging is to page by using the system’s
remote paging terminal
. The remote
paging terminal can be set within a range not exceeding 1km from the center (including in the machine
room—provided to the on-duty person specially for partition paging). The “paging setting” is used to
set the volume of each remote paging channel.
4
—
10.3
Click “paging setting” to enter the setting interface, and drag the 4 volume adjusting sliders, then you
can adjust the volume of the 4 remote paging channels, which should cooperate with the volume
adjustment of the back panel of
remote paging terminal
. In principle, the latter should be as large as
possible (subject to distortionless terminal output). And the volume adjustment here is subject to the
distortionless partition amplifier. And finally, click “confirm” button and return back.
4
—
11
Phone setting
Click the “phone setting” in the “systems setting” to enter the phone parameter setting interface. The partitions
receiving phone calls and response entrances (sound sources) can be set in advance; and you can also set if the
caller needs to enter the password.
4
—
11.1
Click the partitions receiving phone calls, and there will be a phone icon, showing that phone calls are
received by these partitions. Click the sound sources responding phone calls, then these sound source
entrances will respond phone calls. The prior sound source, normal sound sources 1, 2 and 3, and 4
remote paging sound sources can be set to respond phone calls, and other sound sources can not.
4
—
11.2
Press the “inquire password” or “not inquire password” button, to determine if a password is needed to
automatically connect the phone calls. Press the “set password” button to set the call password. The
password consists of four numbers, and it will be effective only when it is entered twice with the same
numbers. And finally, click “confirm” button and return back.
4
—
11.3
If a password is inquired, the caller should enter the set password after hearing two beeps, and press # to
complete it, otherwise, the call will not be connected.
