10
Hand Strap Removal and Replacement
To remove hand strap:
1. Rip the Velcro strap off
2. Remove the battery from the terminal
3. Remove the bottom / upper Strap hook
4. Install the new hand strap in reverse order.
Installing bottom strap hook
Insert the lower strap hook into the groove on the
bottom of the terminal.
Installing upper strap hook
Insert the upper strap hook into the groove on the
upper of the terminal.
Battery
Caution
If the Product is wet, do not put it in a device that may heat the terminal (heater, microwave oven, etc.).
Heating batteries may cause an explosion, deformation or fault. (Water or any other liquid will change the color of
the label inside the terminal.
Battery power source
Series
Description
DS4A
3.8V, 4,000mAh (15.2Wh)
You may need to fully charge the battery before using your terminal for the first time. Battery can be charged
using below listed accessories
Charging Accessory
Charging Time
Specification
Mini USB cable
About 4hours 30minutes
5V, 3A
Desktop cradle and AC adapter
About 4hours 30minutes
5V, 3A
