DSE Italy -
Turin - Italy - WWW.DSE.EU
DSE Italy -
Turin - Italy - WWW.DSE.EU
RE-BCC8YH
USER MANUAL
Product Composition
Camera Cable
connection
power and video output
integrated support bracket Power supply 12V
2A
The camera
The RE-BCC8YH camera cameras are part of the category
protected container.
I'm
cameras very practical because they can be installed even in
hostile environments or outdoors without the need of a
protective case. The housing is completely sealed and can
be exposed to rain. The camera is designed to allow the
reading of license plates of vehicles
is
It provides
shooting
monochrome.
IS'
possible
read the plaque in all light conditions and with headlights
switched on or off. The vehicle may be stationary or moving
at a speed up to 180 Km / h
Target
The camera comes complete with auto iris varifocal lens
10-
40mm. not interchangeable.
Power to the camera
from
bracket
camera
protrudes a cable with the BNC connector for video output
and a Plug for the 12VDC power supply. To which connect
the power supply supplied or equivalent of at least 2A.
Connect the video
The female BNC video connector must be connected to the
monitor or the video management device. If the distance to
be covered is a few meters you can use any type of cable.
But if you go over 10 meters we recommend using the type
RG59 coaxial cable that allows the wiring over a hundred
meters.
Camera attachment
The camera is mounted with the aid of
stirrup
articulated
provided
fixing it to the wall with dowels. Given the sensitivity of the
recovery should be put particular care in choosing the
location.
The camera should be positioned along the direction of
veivolo but in order to resume the plate in a manner not
perfectly frontal
(angle
ideally between 8 and 35 °). And the reading of the front
license plate or rear 'as possible. The camera shall be
positioned at a minimum height of 1.5 m. in such a way that
the angle between the vehicle and the target at the point of
ideal recovery is comprised between 10 and 38 ° C.
The recommended distance for good vision from 5 to 30
meters per second
of the
regulation
lens. See mounting drawing.
To orient the camera loosen the allen under the articulation.
Removing the protections
To open
there
protective custody
removing the 4 allen screws that secure the cover. Remove
the protections placed in the camera protection.
Focus the lens.
One time
had access to
camera is necessary to proceed to the adjustment of the
focal length and the lens focus. Acting on the lens nuts up to
frame in the best way the roadway at the distance at which
you want to carry out the reading (between 5 and 30 meters).
Once adjusted the
lens fix
the camera
Be sure to position the
It can forward close to the front glass.
Settings
On the back of the camera are placed 2 trimmer that as a
rule there is no need to change, but which may serve to
better tailor specific shooting conditions.
CURRENT:
Adjust the intensity of infrared light.
CURRENT:
Adjust the intensity of infrared light.
LUX:
Adjust the IR illuminator activation threshold. Turning to
LUX:
Adjust the IR illuminator activation threshold. Turning to
the
-
the IR will be activated in a condition of greatest
darkness, turning towards the + IR it will be activated under
conditions of greater brightness.
Housing lock
Once setting is finished and verified the functionality of the
camera in the reading plates must reseal the housing finco
tightening the screws. The housing is heated in order to
resist any
temperature stage
external.
IR Illuminator
There
camera
integrates
a
illuminator
to
infrared
to
automatic switch that uses the illumination
of
LED
exclusively for the vision of the plate and does not allow the
vision to the surrounding environment dark. And the camera
'can be used in the same environment for
there
read license plates and other standard IR cameras.
read license plates and other standard IR cameras.