NOTE: The DSE9473 & DSE9483 chargers are designed to be mounted
the base to a vertical surface with the terminal strips at the bottom.
NOTE: This document is intended as a ‘quick start’ guide only. For full
operating instructions and specifications, refer to DSE publication:
057-085 DSE9xxx Operator Manual.
D E E P S E A E L E C T R O N I C S
DSE9473 & DSE9483 Installation Instructions
DANGER OF DEATH: LIVE PARTS exist within the DSE9473 & DSE9483
enclosures. The enclosure cover must not be removed.
INSTALLATION
The DSE9473 & DSE9483 battery chargers are designed to be mounted within a
control panel, utilising the integral mounting holes. The DSE9473 & DSE9483
battery chargers are fit-and-forget. It may be permanently connected to the supply
and the load, with no requirement to disable the charger during times of heavy
load (such as engine cranking) or when in parallel with a charging alternator.
BATTERY SUITABILITY
The chargers are factory set by DSE to suit Lead Acid batteries and may be
ordered to suit other battery types. Additionally, configuration is possible using the
DSE Configuraiton Suite PC Software to suit other battery types.
Care must be taken to ensure the batteries connected to the charg
correct ‘technology’ to suit the setting of the charger.
INDICATIONS
The DSE9473 & DSE9483 Battery Chargers feature LED indicato
battery charger status.
DIMENSIONS AND MOUNTING
Case Dimensions
205 mm x 135 mm x 80 mm
(8.0 ” x 5.3 ” x 3.1 ”)
Mounting Holes
Dimensions
Suitable for M4
(0.2 ” diameter)
Mounting Hole Spacings
190 mm x 120 mm
(7.5 ” x 4.7 ”)
designed to be mounted with
the base to a vertical surface with the terminal strips at the bottom.
: This document is intended as a ‘quick start’ guide only. For full
operating instructions and specifications, refer to DSE publication:
Installation Instructions
053-185
ISSUE 1
473 & DSE9483
designed to be mounted within a
mounting holes. The DSE9473 & DSE9483
be permanently connected to the supply
and the load, with no requirement to disable the charger during times of heavy
load (such as engine cranking) or when in parallel with a charging alternator.
to suit Lead Acid batteries and may be
ordered to suit other battery types. Additionally, configuration is possible using the
to suit other battery types.
be taken to ensure the batteries connected to the charger are of the
feature LED indicators to show the
