Dru Maestro 60/2 Tall RCH, Installation Manual

Page: 41 / 68

I nst allation manual
4 1
8.1.4 Reinstalling glass pane
Reinstall the glass pane once the appliance has been correctly adjusted, the wood set has been installed, the glass pane is
clean or following maintenance. Proceed as follows to reinstall the glass pane (see fig. 8-4).
1
Grasp the glass pane on both sides at the bottom and hold the pane at the angle of the open position (1).
1
Push the profile at the base of the glass pane into the vertical position, and hold it in position (2).
1
Place the glass pane into the correct position. This is dead centre in front of the appliance, with the profile at the base of
the glass pane above the slot.
1
Allow the glass pane to drop into the slot and press it firmly into position.
1
Place the catch brackets back in the holders (3).
1
Close the glass pane (see section 8.1.2).
3
- Avoid damage to the glass pane and appliance.
- Avoid fingerprints on the glass pane by wearing suitable gloves.
3
- Ensure that the glass pane is properly centred.
- Make sure the groove in which the glass pane is placed is free from dirt prior to installing the glass pane.
- Make sure the front glass pane makes full contact with the side pane(s) (there must be no opening between the side
pane(s) and the front pane).
1
3
2
2x
38C-2628
8-4