Dru Maestro 60/2 Tall RCH, Installation Manual

Page: 20 / 68

I nst allation manual
2 0
7.2.4 Back wall connecting to the glass of the side pane
(see fig. 7-8 and 7-9)
When constructing the wall up to the side pane, proceed as follows:
1
Construct the back wall with the correct dimensions (see fig. 7-8).
1
Loosen the self-tapping screws of the vertical decorative strip by a few turns and adjust the profiles to the
correct distance. The distance depends on the thickness of the wall. For material thickness 20 mm and 30 mm, indicators
have been applied. The cover plate is no longer required and can be removed. Re-tighten the self-tapping screws
(see fig. 7-9).
1
Maintain a 5 mm distance between the wall and the side pane.
3
- With two-sided appliances, the front glass pane must be able to open along the wall, and the glass pane must not be
able to come into contact with the wall.
3
- In case of materials up to the glass, it is important to maintain a 5 mm minimum distance from the glass!
- Where materials are installed up to the glass, heat-resistant material capable of withstanding temperatures of at least
100°C must be used.