Remove the two knobs on the rear cover and
unscrew the knob on the end of the freewheel
mode lever. Lift up carefully on the rear cover to
remove. The rear cover will still be connected to the
scooter by the white taillight connector cable.
Install the seat post. Ensure that the seat post
is aligned so that the two flanges with holes are
facing the rear of the product. Having these flanges
rotated into any other position will result in instability
in the seat.
Attach the two battery connectors to the
batteries (red to red and black to black).
Remove your scooter from its packaging. Raise
the tiller by pushing down on the tiller lever, lifting
the tiller into place, then releasing the lever.
Replace the rear cover, making sure the tabs
on the bottom of the rear cover fit into the slots
in the scooter’s floorboard. Replace and tighten the
two knobs and the freewheel mode knob removed
in Step 2.
From behind the product, looking forward, insert
the seat bolt into hole on the left side of the seat
post. This bolt is also used to adjust the seat height.
Insert the bolt as far into the hole as it will go, making
sure that the bolt passes all the way through to the
hole on the opposite side. Install the washer and nut
and tighten them using the included flat wrench.
Lift the seat and pull the swivel lever up at the
same time. Lower the bottom of the seat onto
the seat post. Release the lever, swivel the seat
and push down on the seat until it locks in place.
1
NOTE: Get help when placing the seat onto the
post to avoid scratching the cover shroud.
1.
2.
3.
4.
5.
6.
7.
8.
Insert the armrests into the attachment points
in the seat frame so that the armrests face
forward.
Please Read Before Operating!
For technical assistance, call toll free (866) 621-4933 or (800) 544-5155.
Quick Start Guide
Osprey
