6. Pull on the catch (arrowed) on the tiller to unlock. Then pull
up the tiller until it is set at the correct height for the user.
Push the catch to lock the tiller.
7. Adjust the tiller angle by pressing the lever (arrowed) whilst
pulling or pushing the tiller to the correct angle. Release the
lever to lock the tiller in position.
8. Insert the armrest into the receiver.
Note: The angle of the armrest may need adjusting.
Please refer to the procedure on page 21
9. Secure the armrest by screwing the threaded knob into the
hole (arrowed).
10. Remove the protective film wrapping on each of the four
tyres (not shown). This only needs performing the first
time the scooter is set up.
11. Insert the key into the ignition and turn to start the scooter.
12. CHARGE BEFORE USE
Plug the mains lead into the charger, and then
plug the round connector from the charger into
the charging socket of the scooter.
Finally switch the charger on at the mains.
The scooter can be charged either unfolded or
folded (refer to user manual for folding
instructions).
