Page 10
For technical questions, please call 1-800-444-3353.
SKU 3273
Slide the bit into the Jaws as far as it
2.
will go without inserting the drill flutes
into the chuck.
Hold the bit centered in the Jaws
3.
while turning the Chuck Key
clockwise to secure it in place.
Firmly tighten the Jaws using the
4.
Chuck Key.
Remove the Chuck Key and store it
5.
in the holder on the power cord.
work piece and work area Set up
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to
allow free movement while working.
Secure loose work pieces using
3.
a vise or clamps (not included) to
prevent movement while working.
There must not be objects, such as
4.
utility lines, nearby that will present a
hazard while working.
general Operating instructions
Make sure the trigger is released
1.
and not locked on,
then plug the
Power Cord into a suitable outlet.
Press the Direction Switch of the
2.
Trigger to determine the rotation
direction. Press to the left side for
clockwise rotation. Press to the right
side for counterclockwise rotation.
Squeeze the Trigger to start the tool.
3.
The Trigger has a variable speed
feature. Moving the Trigger slightly
will make the tool operate slowly,
moving the trigger more will cause
the tool to operate faster.
You can lock the Trigger in the ON
4.
position by squeezing the trigger,
pressing in the Lock Button, and
releasing the Trigger. The tool will
operate continuously. To stop the tool,
squeeze and release the Trigger.
Use only well-sharpened bits that are
5.
in good condition and appropriate to
the task.
Use firm pressure when drilling,
6.
but do not press too hard. Too
much pressure will cause the bit to
overheat, may cause the bit to bend
or break, cause undue strain on
the tool, and may damage the work
piece. Pressing too hard may stall the
motor.
if the motor stalls, release the
7.
trigger immediately to prevent
damage to the tool.
Only drill in a straight line. Bending
8.
or twisting the bit while drilling may
cause the bit to bend or break and
may damage the work piece.
Back off your pressure if you are
9.
about to penetrate the other side of
the work piece.
Keep the motor running when pulling
10.
the bit out of a completed hole to
prevent the bit from jamming.
