07-01759B 2012-04 Warranty 07-01760
1
Dri-Eaz Products, Inc.
Owner’s Manual
Dri-Pod™ Direct Flow Carpet Dryer
Patent Pending
The Dri-Pod is a high velocity airmover that creates an aggressive 360°airflow
across floor surfaces to accelerate drying.
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
Read and understand this manual before operating.
WARNING!
To reduce the risk of fire or electric shock, do not
use this fan with any solid-state speed control device.
WARNING!
Unit must be grounded. Do not use with an
extension cord. Connect only to an outlet provided with a ground
fault interrupting device.
WARNING!
Never operate a unit with a damaged power cord, as
this may lead to electrical or fire hazards. If power cord is
damaged, it must be replaced by a cord of the same type and
amperage rating.
WARNING!
Do not touch grills when unit is operating.
NOTICE:
Keep motor dry. For indoor use only.
NOTICE:
Unplug when not in use or when moving unit.
NOTICE:
Do not allow children to play with or around the unit.
Be sure the unit is inaccessible to children when not attended.
NOTICE:
Always operate the unit on a stable, level surface so it
cannot fall and cause injury.
OPERATING INSTRUCTIONS
1. Unwrap the cord and plug the unit into a standard 115V
outlet. CAUTION: Be sure switch is in the off position before
connecting unit to power outlet.
2. Position the Dri-Pod in the center of an area to be dried.
Switch on. The Dri-Pod can dry an area approximately
10 × 10 ft. (3 × 3 m).
3. When surface is dry to the touch, switch unit off and
reposition the unit in the next section to be dried.
4. When finished, unplug the unit and re-wrap the cord in the
cord wrap.
Transporting and Storing
1. Always use the handle to load or carry the unit. Units may
be stacked for transport and storage.
2. When transporting in a vehicle, secure the unit carefully to
prevent sliding and damage to the unit and/or injury to
vehicle occupants.
PARTS IDENTIFICATION
FOR SERVICE CALL YOUR LOCAL DISTRIBUTOR or the Dri-Eaz
Service Department at 800-932-3030
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA USA 98233
Fax: 360
-
757
-
7950
Phone
: 360
-
757
-
7776
www.dri-eaz.com
SPECIFICATIONS
Model
F451
Weight
10.6 lbs. | 4.8 kg
Dimensions
(D × W × H)
15.2 × 15.2 × 8.9 in.
38.5 × 38.5 × 22.5 cm
Amp draw
1.1 amps
Control
On/off switch
Power
235W/115V
Cord length
10 ft. | 3 m
Fan
5 blades
Construction
Injection molded housing, wire grill
Safety
ETL approved to UL and CSA standards
Specifications are subject to change without notice. Some values
may be approximate.
Handle
On/off switch
Cord wrap