DRESSTA 515C, Operator'S Manual, Page: 46 / 205

MACHINE TRANSPORT AND STORAGE
SECTION 3
Page 9
DRESSTA OM515C520C99/1E
MACHINE STORAGE
20. It is recommended to pour 50 [ml] VCI type 1 oil per HMS B00-0006 Standard to the hydraulic
reservoir.
21. Remove the batteries and place them on wooden skids. Then store them in a cool, clean,
dry, well-ventilated place away from areas provided for storing or dispensing fuel and oil, not
near any heat source and preferably where the temperature range is between 0 [
° C] to +21
[ ° C] . Be sure the batteries are fully charged.
IMPORTANT: Do not place battery on a concrete floor or in temperature below 0 [
°°
C].
IMPORTANT: If the machine is stored with dry charged batteries or no batteries, the alternator
output lead (+) must be disconnected and insulated. Failure to do so may result in permanent
damage to the alternator.
22. If the bucket is detached for storage, secure the cylinder piston rod to the machine to avoid
damage.
23. Coat all machined and unpainted surfaces with chassis grease to prevent rust. It is
recommended to use AKORIN N-2 grease.
24. If it is desirable to leave the tires on the machine, jack the machine up and place it on blocks
leaving the tires in suspension. Deflate and cover the tires. Tires should not be exposed to
direct sunlight or any fuel or solvent vapors.
WARNING: Use extra caution when jacking up the machine. Jacking up the
machine can be hazardous if performed improperly. Use jacking equipment of
sufficient capacity. Be sure the jacking points are strong enough to support the
machine. Be sure the jack is stable and well supported. Before jacking up the
machine, block the tires which will not be lifted. Lock the frame halves together
with the locking bar and pins. If the rear tires are being lifted, block the rear axle
to prevent it from pivoting unexpectedly. DO NOT run the engine with the
machine on jacks.
3.4.2. SERVICING DURING STORAGE
ONE-MONTH REPETITIVE SERVICE PERIOD
Be sure the batteries are fully charged. Never allow batteries to run down below 3/4 full charge.
WARNING: DO NOT charge batteries in a closed area. Provide proper ventilation
to guard against explosion of an accumulation of the gas given off in the
charging process.
SIX-MONTH REPETITIVE SERVICE PERIOD
1. Visually inspect the engine and radiator for leakage and other defects. Correct all defects,
consult Authorized Construction Equipment Distributor if necessary.
2. Remove all seals from the machine ports: crank-case and hydraulic breather plugs, engine air
intake, fuel tank vent lines, etc.
3. Install fully charged batteries. Refer to "BATTERIES", Section 5.
WARNING: Be sure the electrical system master switch is off when connecting or
disconnecting batteries to minimize the chance of sparks and explosion.