Folding Shower Seat SHST-01-TK/PL manual– Ver 2 Rev 2 01/2016
6
Figure 2
Figure 1
LEVEL
Folding Seat Installation Instruction
1.
Place the
Installation template
against the wall at the
desired height. Align your level along the line marking
the top of the seat (see Fig 1) and adjust the template
so that it is level. It is recommended to mount the seat
approximately 17”-19” above the floor, however the
mounting height can vary slightly depending on
personal needs or preference. Once leveled, secure the
template to the wall using painter’s tape (or similar)
and mark all 10 holes for drilling.
2.
The folding shower seat can be installed into either wood reinforcement or concrete
behind the finished wall. See installation options below:
FOR installation into wood reinforcement behind the finished wall:
Drill the holes using
a 7/32”diameter drill bit.
For installation into wood reinforcement, the holes need to be
drilled through the tile and drywall only.
Do not
drill through the wood framing; let the
screws bore into the wood.
FOR installation into concrete behind the finished wall:
Use the supplied template to
mark the holes at the desired height. Use a 5/16”diameter drill bit and install the supplied
wall anchors flush to the finished wall. Exercise caution when using a hammer to install the
wall anchors so as not to damage the tile.
3.
Hold the seat to the wall in the folded (up)
position (see Fig. 2), align the brackets to the holes
and attach the
Left and right support brackets
(part#03)
using 6 of the
ST5 x 70mm screws
(part# 06)
NOTE: Additional reinforcement must be present behind the mounting wall prior to
installation. This seat has a maximum weight limit of 250 lbs. when installed properly.
