© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
Tools Needed
Parts Needed
SAPPHIRE-V Shower and Tub Door Manual Ver 1 Rev1 05/2022
23
© 2022 DreamLine® All Rights Reserved
Roller Wheel Adjustment (if needed)
04
x4
Fig 16
disk
small allen wrench
cap
disk
wheel
small hole
TIP:
The wheel assembly bushing that fits through the hole in the glass is elliptical.
By rotating this disk, the door glass can be adjusted (tilted) slightly in order to make even contact
between the walls and the Bulb Vinyl Inserts and prevent leakage.
◾
Only adjust one wheel at a time
◾ “Hand” the doors in the desired positions (adjusting for one wall may not match the opposite wall)
◾
Use a shim beneath the door glass to prevent contact with the threshold during adjustments
◾
Temporarily lower the roller guards to allow clearance to adjust the rollers
◾
Remove the cap from the wheel assembly and loosen the bolt
◾
Insert a small allen wrench or similar tool into the small hole in the edge of the adjustment disk
to help rotate the disk
(see Fig 21b)
and tilt the door glass to seal with the bulb vinyl in the wall
profile
◾
Hold the glass and the adjustment disk in position and re-tighten the bolt
◾
Test the operation of the door. Repeat the adjustment process on the other rollers if necessary
◾
Replace the Wheel assembly cap
◾
Re-adjust and fully tighten the
Roller Guards (#03)
to within 1/16” of the
Upper Guide Rail (#01)
(Fig 16)
16