Page 16 of 33
J-MINI PRO MANUAL
6
Scanning Results Analysis
6.1
Automated Scanning Results: What You See
The objective of the J-Mini instrument is to detect CVD or HTHP diamonds and identify them to the operator.
Whether they are loose diamonds or mounted into jewelry, the results of J-Mini scanning are displayed
in a similar manner. The intelligent, automated software that has been developed by DRC draws a
colored box around detected laboratory grown diamonds. While this system is highly accurate, it is now
possible to achieve a heightened level of accuracy by means of additional examination of light
performance features for the operator to examine.
6.2
Basic Detection Results
Detection that immediately identifies more than 98% of laboratory grown diamonds is shown on the
chart below.
CVD or HTHP
Laboratory Grown
Diamonds
Review This Stone
Under
Fluorescent Light Tab
Recheck These Stones
Using Fluorescent,
Photoluminescent, and
Phosphorescent Tabs
Green Box Blue Circle
These stones are almost
certainly laboratory grown;
HTHP or CVD diamonds.
Green Box Red Circle
Examine these stones under
the fluorescent tab. If they
fluoresce, they are natural.
Blue Box Red Circle
Recheck these stones using
all featured tabs and the
instructions below.
These boxes will surround each diamond that is detected as laboratory grown so that identification is
accomplished more easily and rapidly. When scanning small stones that are closely grouped, it is possible
that a single box may surround more than one stone.
