Section 5 -
Attaching Fascia
1.
Place groove along top of
fascia over endcaps, and
snap into place.
Fascia is not fully seated
until it clicks into place on
both ends.
2.
Once in place, check for
secure fit. If necessary,
secure with appropriate
fasteners
(not included)
.
STEP 2
Clicks into place
STEP 1
Figure 5
page 7 of 8
Dual Roller Clutch-Operated FlexShade
®
ROLLER
ASSEMBL
Y
(OPERATOR E
ND)
9.
If installing Fascia, see
Section 5 - Attaching
Fascia
. If not, snap on
Endcap Covers.
6.
Replace chain
guide cover.
Figure 4-E
Figure 4-G
5.
Route bead
chain through
chain guide
8.
Use the included Adjustment
Tool
(C202.029)
in the adjustment
point on the underside of slide to
level shade.
7.
Replace slide and
safety screw:
Place into groove at
an angle, slide up, and
ensure bottom of the
slide is hooked into
the receiver.
Figure 4-H
Figure 4-F
