Overview -
Access Fit E and V Components
Section 1 -
Removing Shipping Brackets
(Tab-Tensioned, "V" Surfaces only)
Caution:
DO NOT remove shipping brackets until product has been mounted and connected to
power
(see Section 4 in this document.)
. Also, DO NOT OPERATE SCREEN BEFORE
removing shipping brackets from screen case.
Section 2 -
Hanging Screen
Please Note:
When locating viewing surface and checking clearance
for screen operation, ensure that surface is centered in
the case.
1.
Engage each case mounting bracket
(attached to case)
with top of
housing
(Fig. 2)
and tighten set screws.
2.
Screen should be sufficiently supported to withstand vibration.
Please Note:
A hoisting bracket is included on each end of the case
to aid in overhead installation.
3.
Ensure that fasteners are of adequate strength and suitable for the
mounting surface chosen. Supporting hardware such as chains,
cables, two
3
/
8
"
(9.5 mm)
rods, etc., must be
precisely
vertical.
4.
Entire bottom of case must be readily accessible after installation is complete.
5.
Front, back and top of case must be straight—not forced to warp or bow.
Caution:
Screen case and flange are not designed to serve as ceiling support.
6.
Do not seal unit in ceiling until electrical connections have been made and screen
operates successfully.
Please Note:
If case is painted on location, removal of roller/fabric assembly is
recommended prior to painting. If not removed, slot on bottom
of case should be shielded to protect viewing surface from paint
splatters/overspray.
If you have any difficulties installing or servicing your
Access Fit Screen, call your dealer or Draper, Inc.
Electrical
Cutout
Tab Tensioning
“V” Dowel
“E” Dowel
Mounting Bracket
Mounting Bracket
Hoisting Bracket
Leveling Brackets
Hoisting Bracket
“E” Free Hanging
Viewing Surface
“V” Flexible Vinyl
Viewing Surface
Trim Flange
Shipping Brackets
Attached to Dowel
and Screen Case
(V Screens Only)
CAUTION
Read and understand all warnings (p. 2)
before beginning installation.
Please Note:
Shipping brackets must
remain in place until product has
been mounted and connected to
power
(see Sections 1 and 4 in this
document)
.
Also, DO NOT operate screen
before removing shipping
brackets from screen case.
3. Loosen screws
and remove the
shipping bracket.
1. Remove Fasteners
from Bracket Clamps
2. Run the screen
DOWN to expose
the Dowel Screws
4. Retighten dowel
endcap screws.
Figure 1
CASE
MOUNTING
BRACKET
7
/
8
"
(22
MM
)
ELECTRICAL
CUTOUT
HOISTING
BRACKET
TYPICAL
INSTALLATION
(Brackets may be angled to meet
installation requirements.)
CASE
MOUNTING
BRACKETS
ALTERNATE
INSTALLATION
CASE
MOUNTING
BRACKET
7
/
8
"
(22
MM
)
ELECTRICAL
CUTOUT
HOISTING
BRACKET
TYPICAL
INSTALLATION
(Brackets may be angled to meet
installation requirements.)
CASE
MOUNTING
BRACKETS
ALTERNATE
INSTALLATION
Figure 2
Installation of Case
Please Note:
Extra brackets
must be ordered for
alternate installation.
TOOLS REQUIRED
PENCIL
POWER DRILL
TAPE MEASURE
LEVEL
HARDWARE
(by others)
Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385
draperinc.com | 765.987.7999 | 800.238.7999
© 2019 All Rights Reserved
|
FORM: AccessFit_220V_Inst19
Access FIT E and V 220V
Electric projection screen
INSTRUCTIONS
INSTALLATION & OPERATION
