37
5.3.
Functions of the user interface “Edit polygonal course”
In addition to optimising the polygonal course (see Chapter 3.2.3), you can also use this user
interface to check the log diameter detected by the system and edit it if necessary.
5.3.1.
Checking the log diameter
By pressing the button 2.2.8.1 “Circle” you can switch to the view of the face diameter. As
shown in Figure 23, the diameters are displayed as yellow circles on the faces of the individual
logs. The middle of the circle is the basis of the assessment.
As with editing of the polygonal course, you can use the navigation bar to traverse along the
woodpile.
Figure 24: Viewing the diameter
Summary of Contents for sScale
