Dragonfly Energy DFGC2H, Instruction Manual

Page: 3 / 8

Dragonfly Energy Heat Enable Instruction Guide | Edition. HIM_HeatedRev008_07282022 3
What's in the Box?
Upon arrival, please verify your heated battery includes the items listed below.
See Figure 1 and Figure 2.
• 1 - SPST Rocker Switch ( Figure 1 )
•
1 - 25’ 18 AWG wire terminated with 0.187 QD and #8 ring lug ( Figure 1 )
• 1 - 25’ 18 AWG wire terminated with 0.187 QD and 5/16 ring lug ( Figure 1 )
• 1 - Jumper Wire ( Figure 2 )
Figure 2: Jumper Wire
Figure 1: Heat Battery Kit
If you need to modify the harness, use the following items:
•
(2) 3/8” ring lugs
•
(2) 5/16” ring lugs
•
(2) #8 ring lugs
•
(4) 1-inch pieces of shrink wrap
•
(1) Extra M4 x 4mm long Philip head screw
If you purchased more than one heat battery you will receive a Heat Battery Add-on Kit ( Figure 3 ) which provides the
necessary components to daisy chain the heat-enable posts. This allows for each battery's heat function to be enabled
and disabled via a single rocker switch.
Items in the Add-on Kit include:
If you are installing more than one heat-enabled battery you will need the Add-on Kit.
See Figure 3.
•
(1) 14-inch 18 AWG wire terminated with two #8 ring lugs
•
(2) M4 x 5mm long Philip head screws
•
(1) #8 ring lug
•
(1) 1-inch piece of shrink wrap
Additional Tools Needed for Install:
*See Figure 4. Items not provided.
•
#2 Phillips screwdriver
•
¾ inch Forstner drill bit, step bit, or equivalent
•
220 grit sandpaper
•
½” wrench
•
½” socket wrench
•
torque wrench set to 10 ft-lbs.
Figure 4: Additional Tools Needed
Figure 3: Add-on Kit