DragonEye Compact Speed LIDAR Operator Manual
DragonEye Technology, LLC / Doc. 30666 Rev. 03
29
ECCM Control
The ECCM menu allows the operator to temporally disable the
LIDAR’s Electronic Counter-Counter Measure (anti-jamming) system.
To activate or disable the ECCM, press
then use the up/down
arrows
to select “ECCM” and press
. Then use
the up/down arrows to select “Active” or “Disabled” and press
to confirm your selection. If ECCM is disabled, the LIDAR unit
will return to ECCM “Active” if it is not in use for a few hours, if the
batteries are replaced, or if “Load Defaults” is selected.
Note: While the DragonEye Compact Speed LIDAR
TM
is fully
functional with ECCM set to “Disabled”, the ECCM setting should be
left in the “Active” state during normal operation to give the full
protection against laser detectors and jammers.
Input / Output Port
A mini USB style connector is located on the bottom of the unit. This
connector can be used to collect speed and range measurement data
during operation using a standard cable and custom software
provided by DragonEye Technology. Contact the manufacturer for
further details regarding use of the I/O port.
Note: The protective rubber strip covering the mini USB connector
forms part of the Lidar’s water resistant seal. After using the
connector, carefully replace the rubber cover and ensure it is seated
properly.
MENU
MODE
ENTER
MODE
ENTER
