DragonEye Compact Speed LIDAR Operator Manual
DragonEye Technology, LLC / Doc. 30666 Rev. 03
23
Note, once the operator begins to use the up/down arrow buttons to
set the range limit, the “shoot” option will no longer be available.
Alternatively, the Minimum and/or Maximum range values may be
set by “shooting” a target that represents the particular range limit
(such as a school zone or work zone sign). To shoot the Minimum or
Maximum range, enter the desired menu and instead of using the
up/down arrows, pull and hold in the LIDAR trigger and aim at the
target that represents the Minimum or Maximum range. You may
range to the target multiple times until you are positive the correct
target has been selected. Press the Enter button
to confirm
the value. Once the Minimum and/or Maximum range values are
set, the LIDAR will display only speeds between these values. If a
vehicle is acquired outside of this range window, a target locked
audible tone will be heard but dashes ( - - - - ) will be displayed in the
HUD and on the side display in the speed reading area. Also the
word “window” will be displayed to indicate the target was acquired
outside of the allowable range window. To quickly remove the
Range Window settings, use the Menu button, then use the arrow
buttons to select “Load Defaults”. Press the Enter button to reset all
user settings to default values. Note: The adjustable Maximum
Range Menu may not be available on some units where jurisdictions
may fix the maximum range allowed for the LIDAR devices.
Direction Filter
The DragonEye Compact Speed LIDAR
TM
allows the user to set the
system to display speeds on: 1) Only approaching Vehicles, 2) Only
receding Vehicles or 3) Both approaching and receding vehicles. The
default value is set for both approaching and receding vehicles.
MODE
ENTER
