DragonEye Compact Speed LIDAR Operator Manual
DragonEye Technology, LLC / Doc. 30666 Rev. 03
15
Battery Installation
Lift the rubber battery cover
from the lower corners and
remove the old batteries using
the pull ribbon.
Insert two “AA” cell batteries on
top of the pull ribbon, with
positive end against the flat
contacts and negative end
against the spring contacts.
Replace the rubber battery cover and ensure a good seal along the
tongue and groove interface.
Note: The DragonEye Compact Speed LIDAR
TM
is designed to use
quality alkaline “AA” cells from brand name manufacturers. The
device also functions with rechargeable NiMH “AA” cells commonly
available at consumer stores.
Caution: The LIDAR’s
rubber battery cover forms part of the water
resistant enclosure protecting the unit from rain and moisture.
Please be sure to change batteries in a dry environment.
Powering On
When fresh batteries are installed, the unit will automatically power
up, run through Self Test and be ready for use. (Note: If the LIDAR
is inactive for approximately 30 seconds, it will automatically
transition into sleep mode to conserve battery life. If this happens,
simply click the fire trigger again to wake up the unit.)
