Dräger Infinity Delta, Instructions For Use Manual

Page: 88 / 614

3-12 D
ELTA
/D
ELTA
XL/K
APPA
VF8
3 N
ETWORK
A
PPLICATIONS
Wireless During DirectNet
™
mode
To change the monitor to wireless mode, consult your hospital’s technical personnel
or the Service and installation documentation.
Wireless Messages
In wireless mode, the messages in the following table may appear:
Network Transfer
Patient Data
You can transfer patient data (demographic data, trends, events, and hemo/oxy/vent
calculations) from one monitor to another. Procedures differ according to whether or
not the source and destination monitors are connected to the Infinity network. To
transfer information involving a non-networked monitor, you must use a PCMCIA
memory card. To transfer information over the network, you can use menu options.
See page 4-3 for more information.
Message Condition Display Area
Offline • The monitor travels out of range of AP
or
• The wireless card is removed Network
Invalid memory card • The wireless card is defective Local
Wireless option not
enabled
• The wireless card was inserted without the
wireless option enabled
NOTE : To clear the message, either install
the wireless option or power-cycle the
monitor. Although the message may not
clear, the functionality of the monitor and the
display of other messages is not affected.
Local
Not monitored by central The monitor is connected to the network, but
is not assigned to an Infinity CentralStation
Network
NOTE: Card data transferring from VF8 level software to a lower level software will
work appropriately. Card data transferring from a lower level software to VF8 level
software is not supported.