Dräger CPS 6900, Instructions For Use Manual

Page: 31 / 92

Disposal
Dräger CPS 6900 31
7.3.2 Packing the chemical protective suit in a CPS
storage and transportation bag
1. Place the chemical
protective suit in the CPS
storage and transportation
bag.
2. Fix the visor using hook-
and-loop straps.
3. Place the protective boots
as illustrated.
4. Secure the chemical
protective suit below the
sleeves and on the boots
using straps.
5. Fold up the sleeves on the
shoulders and place on the
sides.
6. Close the CPS storage and
transportation bag.
7. Turn up the CPS storage
and transportation bag to
the middle on the tip of the
boots and directly under the
visor or on the neck,
respectively. Ensure that the visor is located between the
gloves.
8. Turn up the CPS storage and transportation bag in the
middle and close the strap buckles.
8 Disposal
8.1 Withdrawal from service
The chemical protective suit must be withdrawn from service in
the following situations:

It has been damaged and repair is not possible.

It was contaminated and cannot be decontaminated
anymore due to the characteristics of the hazardous
substance.

The material of the chemical protective suit has altered: it
shows embrittlement, swellings, colour changes, surface
maceration or similar.
In case of doubt please contact Dräger for more information.
8.2 Service life
The material properties of the chemical protective suit will be
maintained for at least 10 years from the date of manufacture
if not used and if stored under the recommended conditions,
with the recommended maintenance intervals. The service life
may be reduced despite correct storage and servicing if the
suit is used frequently.
8.3 Disposal instructions
The chemical protective suit must be disposed of in
accordance with the applicable regulations.
9 Technical data
9.1 General
Sizes in cm:
NOTICE
The chemical protective suits can be disposed of
thermally or on waste dumps. The type of disposal
depends on the contamination.
i i
Suit
size
Height Chest
measurement
Waist
measurement
S 150-165 80-118 72-106
M 160-175 80-118 72-106
L 170-185 80-118 72-106
XL 180-200 104-124 95-110
XXL 195-210 104-124 95-110
Weight:
Suit size L,
with boots size 45,
without accessories
approx. 6.8 kg
Suit size L,
with boots size 45,
with accessories
approx. 8.0 kg
Suit size L,
with socks,
without accessories
approx. 4.3 kg
Material:
Chemical protective
suit
Umex
Visor Special polyvinyl chloride
Gloves FKM or
FKM/Butyl or
Butyl or
Laminate: HPPE or
Para-Aramid or
Para-Aramid
Safety boots Nitrile-P
black, FPA-CR safety boots with plastic
sole, cut and fire resistant, textile lining
inside, sizes see Chapter 11 on Page 36
PVC:
yellow, black grip sole, sizes see
Chapter 11 on Page 36
Colours:
Outside/inside red/red
Temperatures:
During use
-40 °C to +60 °C
1
For short-term exposure, lower
temperatures (up to -80 °C) are possible
and have been tested by Dräger for the
material Umex, but not as part of the
prototype tests.
Observe operating temperatures of the
respiratory protective equipment!
1 tested by Dräger
During storage -5 °C to +25 °C