Dräger Medical Narkomed GS, Setup And Installation Manual

Page: 14 / 92

3
Setup and Installation
3-4 Narkomed GS Setup and Installation Manual Draeger Medical, Inc.
Installing the
Vaporizers
(Fixed Vapor
Mount
System)
The following procedure applies to the fixed vapor mount system used on
2-vaporizer and 3-vaporizer machines, for Dräger 19.1 vaporizers.
If your machine is equipped with a removable vaporizer system, skip to the
next procedure.
Install each vaporizer as follows:
1. Remove the back cover from the vaporizer exclusion system.
2. Remove the vaporizer from its shipping container.
3. Remove the tape from the back of the vaporizer. Verify that the
vaporizer's O-rings are present at the inlet and outlet ports.
4. Unscrew the plastic plates that are mounted over the vapor ports. Save
the screws that you remove.
5. Using the saved screws from the previous step, secure the vaporizer to
the appropriate location on the manifold (see “Selecting the Vaporizer
Order” above), and tighten the screws.
WARNING: Use only the screws from the plastic plates.
6. When all vaporizers are installed, test the exclusion system for proper
operation. If adjustment is needed, refer to the Narkomed GS Service
Manual. Reinstall the back cover.
SU00109
MANIFOLD
VAPORIZER
VAPORIZER
MOUNTING SCREWS (2X)
COVER SCREWS
AND
WASHERS (4X)
BACK
COVER
O-RINGS
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS