Operating instructions
Disinfectant and liquidsoap dispenser
SPE 500/SPE 1000
with lever and disposable pump
Before assembly
Unpack the box, remove the plastic packaging around the dispenser and make sure that
the following parts are included:
1
dispenser with mounted plastic disposable pump
1
lever to be mounted on the dispenser (see 1 a)
1
wall plate for wall attachment (not necessary if there is already a suitable wall plate
available and mounted)
1
drip tray (for insertion after the dispenser has been mounted)
1
bag with a set of three screws and dowels as well as a metal stripe
1
operating manual in German or German and English
1
Installation/Operation
1
a Complete assembly of the dispenser
For reasons of space, the dispenser is delivered with the lever removed (Fig. 1). To assemble it
• on the back of the dispenser, insert the lever and press until you hear it lock in place; replace the metal strip (is used to secure
the lever, and at the same time as the upper attachment point for the dispenser on the wall plate)
1
b Mount dispenser
• Attach the wall plate using the dowels and screws (Fig. 3), (not necessary if a wall plate is already available)
• Push the dispenser into the wall plate from the top until you hear the locking pin lock in place
2
Initial use
• Open the dispenser, to do this press the button at the top underneath the lever (Fig. 2) and fold the cover down forwards
• Push the locking pin of the wall plate out through the recess in the back of the dispenser, pull the wall plate down and out of the housing
• Push a full bottle (disinfectant or soap) over the dispenser pump from below and insert it in the housing (Fig. 4); close the housing cover and
insert the drip dish
• The fi rst time you use the dispenser, press the lever down as far as it will go several times until liquid comes out of the pump nozzle, collect
this in a suitable receptacle
Note: Determine the position of the dispenser before mounting it on the wall
• Attach above a washbasin if required (not necessary because of the integrated drip tray)
• Mounting height above a washbasin: ca. 15 to 20 cm (bottom edge of dispenser)
• Mounting height (fl oor to bottom edge of dispenser) on the wall: approx. 120 cm
• If dispensers are mounted in corridors: Choose the mounting height in such a way that the dispensers cannot become damaged by
ward trolleys or similar
3
Dosing unit
• On delivery, the dispenser pump is set to the maximum dosing quantity of 1.8 ml per stroke
• This amount can be reduced to 1.2 ml or 0.8 ml per stroke by moving the dosing fork to the right or left (Fig. 5)
4
Cleaning the dispenser / replacing the pump
• The dispenser is basically maintenance-free, but should be cleaned and disinfected regularly if appropriate on the basis of infection prevention
and hygiene recommendations
• Only use a mild detergent to wipe down the housing, treat with disinfectant afterwards if required
• The housing can also be cleaned in a suitable dishwasher
• We do not recommend cleaning the pump in order to prevent hygiene problems arising: The plastic pumps have been designed as disposable
pumps and can be purchased at a favourable price - maybe at even less cost that would be incurred for cleaning - as a spare part.
For this reason, the pumps should be replaced if necessary, and the used pumps should be disposed of properly
suitable for bottles made by all the major disinfectant manufacturers
Art. no.
00-918-005
for
500
ml bottles
00-918-010
for
1.000
ml bottles
2
3
4
5
