Quintaflex R96
Ceiling, Wall Model
Dr. Mach
Lamps and Engineering
59250001
Edition 01
21.02.2002 / Bak Page
14/18
4.2 Adjustments at the lamp head
♦
Adjusting the lamp bow
For adjusting the lamp bow proceed as follows:
•
Turn off the lamp.
•
Loosen the countersunk screws
1
(covered by
seal
4
) using a cross screw driver and carefully
lift the upper housing part off the seal.
•
Screw the nuts
2
on both sides a little tighter
using an open-ended or ring wrench SW14, or
loosen these nuts while at the same time holding
the screw slot
3
in each case with a screw
driver.
•
Once the adjustment has been made, place seal
4
correctly on the housing lower part.
•
Replace the upper part of the lamp housing, so
that the seal lies cleanly around the
circumference.
•
Using a round object (drawing pin or small screw
driver), lift the seal and lower the lamp housing
upper part until it sits evenly around the whole
circumference.
•
Tighten using the countersunk screws
1
.
•
Press into place seal
4
where widened.
1
4
3
2
1
1
