Dovre 350CB, Installation Instructions And Operating Manual

Page: 43 / 170

2. Pull the baffle plate forwards so that the bolt
comes free from the rear side.
3. Remove the baffle plate via the front door.
As the baffle plate has notches on both sides
of it, the baffle plate can be taken along the
ridges on the side walls and removed from the
appliance without a problem.
Cleaning glass
Dirt clings less easily to well-cleaned glass. Proceed
as follows:
1. Remove dust and loose soot with a dry cloth.
2. Clean the glass with stove window cleaner:
a. Apply stove window cleaner to a kitchen
sponge, rub down the entire glass surface and
give the cleaning agent time to react.
b. Remove the dirt with a moist cloth or kitchen
tissue.
3. Clean the glass again with a normal glass cleaning
product.
4. Rub the glass clean with a dry cloth or kitchen
tissue.
Do not use abrasive or aggressive products to
clean the glass.
Wear household gloves to protect your hands.
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
Make sure that no stove window cleaner runs
between the glass and the cast-iron door.
Lubrication
Although cast-iron is slightly self-lubricating, you will
still have to lubricate moving parts frequently.
Lubricate the moving parts (such as guide
systems,hinge pins, latches and air slides) with
heat resistant grease that is available in the
specialist trade.
Adjusting the air slider
If the air slider (C) of the secondary air inlet does not
move easily, you can adjust the air slider using the
two screws (A) and (B) in the front plate; see following
figure.
Touching up the finish
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
finish available from your supplier.
Checking the seal
Check whether the sealing rope of the door is still
in good condition and works well. The sealing rope
is subject to wear and needs to be replaced in time.
Check the appliance for air leaks. Close any
chinks with stove sealant.
Subject to change because of technical improvements
15